MENU SETTINGS
Alarm Out Time
When you select ALARM OUT TIME , the number indicates how long
(in seconds) the alarm lasts after the sensor detected the motion signal.
If you set CONT, the alarm will keep continuous when sensor detected the motion signal.
If you set OFF , the alarm will not function when sensor detected the motion signal.
Sensor Type Setup
When you select SENSOR TYPE SETUP, you can select NOT INSTALLED, NORMAL OPEN type or NORMAL - CLOSE type sensor to make setting for each channel.
In
In
NETWORK SETUP
| NETWORK SETUP |
> ACCEPT CLIENT | [YES] |
MAC ADDRESS | 30.22.24.23.25.26 |
IP ADDRESS | 192.168.001.090 |
SUBNET MASK | 255.255.255.000 |
GATEWAY | 192.168.991.245 |
| PRESS (< , >) THEN (SELECT) |
| PRESS (MENU) TO EXIT |
(NOTE: THE NETWORK SETUP MENU IS USED ONLY FOR THE SYSTEM WITH OPTIONAL LAN INTERFACE. IF YOUR SYSTEM WITH
CAUTION:
RESET (Initialization): To make the system reset, press ";" button 5 times in the nor- mal view mode. Be aware that all the information (Including password) will be lost. After resetting, the password will be set as the default value (111111).
*After above setting process, press [MENU] button to go back to [MAIN MENU], then you can select other item for setting or press [MENU] button again to go back to View screen for recording function or operate the other function.