Sylvania DVR91VG manual Installing batteries in the remote control, Using a remote control

Before you start

Functional overview (cont’d)

Installing batteries in the remote control

Install two “AA” size batteries (supplied), matching their polarity to those indicated inside battery compartment of the remote control.

1 2 3

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction

below:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery compartment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or public rules for environmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disassemble batteries.

Using a remote control

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor of the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is on the remote sensor of the unit.

•Remote control for different devices can interfere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall-off of the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Line of sight: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23 feet (7m)

	30°
Remote	30°
control

The VCR / DVD recorder switching

Because this product is a combination of a VCR and a DVD recorder, you must select first which component you wish to operate with [OUTPUT SELECT].

VCR MODE

Press [VCR] on the remote control. (Verify that the VCR indicator is lit.)

DVD MODE

Press [DVD] on the remote control. (Verify that the DVD indicator is lit.)

Note:

•Pressing only [OUTPUT SELECT] on the front panel DOES NOT switch the mode of the remote control. You MUST select the correct mode on the remote control.

•You cannot switch to another mode (DVD or VCR) during in the timer-standby mode.

•Pressing [REC/OTR] (DVD) or [REC/OTR] (VCR) on the remote control switches immediately its respective mode so that you can start recording directly on the appropriate media.

s B

VCR button

DVD button

OUTPUT SELECT

VCR s BDVD

DVD indicator

OUTPUT SELECT button

VCR indicator

POWER	T-SET		OPEN/CLOSE
		TIMER PROG.
.@/:	ABC	DEF
1	2	3
GHI	JKL	MNO	CH
4	5	6
PQRS	TUV	WXYZ	VIDEO/TV
7	8	9
DISPLAY	SPACE	CLEAR	SETUP
	0
TOP MENU	MENU/LIST	RETURN	ENTER
REC/OTR	VCR	DVD	REC/OTR
REC SPEED		PLAY
x1.3/0.8	SKIP	PAUSE	SKIP
SLOW	CM SKIP	STOP	SEARCH
DUBBING	ZOOM	AUDIO

10EN