Verify switch operation
Verify switch operation
Use these steps to view port status and to enable ports on the Base Ethernet and the Fabric Ethernet switches.
View port status
1.Verify you are at this prompt.
If you are not at the appropriate prompt, see Connect to the SCM on page 6 for instructions on how to get there.
2.Enter the applicable command for the switch you are verifying.
Switch | Command to enter | Resulting prompt |
Base Ethernet |
| |
Fabric Ethernet |
|
3.Enter this command to show the status of the ports. show port all
View the status information of the ports to see which ports are enabled. If needed, press the space bar to view more of the list.
4.Proceed to the applicable section or step:
To enable all ports, see Enable all ports on page 8.
To enable only specific ports, see Enable specific ports on page 8.
To leave all ports disabled, continue with step 5.
5.Enter the exit command to return to the
If you are asked to save changes, enter y for yes or n for no. If you choose y for yes, this configuration is saved as the startup configuration.
6.Enter the exit command to log off the SCM.
7.If you have two SCMs installed, repeat the above steps on the other SCM.
7
