Talkswitch CT.TS005.002501.UK Save Settings to Talkswitch, Connect Telephones and Peripherals

STEP 6 — SAVE SETTINGS TO TALKSWITCH

This step will transfer the settings you have configured from your computer to the TalkSwitch system.

From the File menu in the TalkSwitch System Configuration window, select Save to TalkSwitch... A progress bar appears indicating that the configuration information is being sent to the TalkSwitch system.

STEP 7 — CONNECT TELEPHONES AND PERIPHERALS

Connect incoming (external) telephone lines

Important! Lightning and electrical surges can cause damage to TalkSwitch. We recommend using surge protection equipment on all external telephone and power lines connected to a TalkSwitch system.

Single line connection (1 incoming phone line per wall phone jack)

Two-wire connector Use the RJ-11 telephone cables provided to connect external phone lines to TalkSwitch. These cables have a two-wire connector for connection to a single line wall jack. Do not use four-wire telephone cables. See “Check your premises telephone wiring” for notes on telephone line and extension wiring. Users in Ireland should use 2-wire RJ-11 to RJ-11 telephone cords.

1. Connect one end of the provided RJ-11 telephone cable 24

to the wall phone jack of an incoming phone line and the other end to the L1/L2 port at the back of the TalkSwitch unit.

2.If necessary, connect a second external phone line to the L2 port of the TalkSwitch unit using the

same method.

3.If you have a TalkSwitch 48, connect the remaining external phone lines to the L3/L4 and L4 ports at the back of the TalkSwitch unit, respectively.

L1/L2 L2

48

L3/L4 L4

L1/L2 L2

H T T P : / / G L O B A L . T A L K S W I T C H . C O M 9