Talkswitch CT.TS005.002501.UK manual Changing TalkSwitch unit ID numbers, Unit ID

Changing TalkSwitch unit ID numbers

Each TalkSwitch unit is pre-programmed at the factory with Unit ID number 1. When you plug multiple units in for the first time or add a unit or units to an existing network, the lights on the front of each TalkSwitch flash. This is an indication that all units have the same ID number. Change the ID numbers so that they are all unique, as follows:

1.Connect a phone to any extension port (eg. E4) of the TalkSwitch unit for which you want to change the unit ID number, and lift the phone handset.

2.The TalkSwitch prompt will indicate that there is an ID conflict. Choose a number, for example “2”, as the new unit ID number. Once the unit ID number has

been accepted, the lights on the front panel will stop flashing (usually within 10 seconds).

3.Repeat the above steps for each additional TalkSwitch unit, assigning a unique ID number to each unit on the network.

After successfully changing each unit ID to a unique number, each unit can be identified by the network. More importantly each local extension, remote extension, and voice mailbox, will have a unique number wherein the second digit in the three digit identifier becomes the unit ID number. See the table below.

TalkSwitch Numbering Scheme for Networked Units
	Unit ID 1	Unit ID 2	Unit ID 3	Unit ID 4
Local Extensions	111-118	121-128	131-138	141-148
Remote Extensions	211-218	221-228	231-238	241-248
Local Mailboxes	111-118	121-128	131-138	141-148
Remote Mailboxes	211-218	221-228	231-238	241-248
General Mailboxes	410-419	420-429	430-439	440-449

Configuring the Networked Units

Now that you have connected your TalkSwitch units and changed the unit ID numbers, you can configure call handling options for the new unit(s). Return to Step 3 — Open

the TalkSwitch Configuration Software and follow the subsequent steps to

complete the configuration of your expanded TalkSwitch network.

H T T P : / / G L O B A L . T A L K S W I T C H . C O M 1 3