Talkswitch TS-100 instruction manual Redial Button, Pause Button, Hold Button, HOLD/FLASH Button

Telephone Features

REDIAL BUTTON

1.If the number you dialed is busy, or you want to call the last number dialed again, lift the handset, or press and release the hookswitch for a new dial tone.

2.Press REDIAL. The number will appear on the display window.

3.The last number called (31 digits maximum) will automatically be redialed.

Note: If you use a hunt group such as ‘9’ to get external dialtone first, you may encounter problems with dialing out since it takes time for TalkSwitch to switch from internal dialtone to external dialtone so the 1st digit of the phone number may be missed by the phone company.

PAUSE BUTTON

The PAUSE button allows you to insert a 3.6-second pause in the dialing sequence. This is particularly useful if you are connected to a PABX system where you must dial an access code (usually the number 9) to obtain an outside line.

1.Press the PAUSE button once and release at any point in the dialing sequence where a pause is desired.

2.The PAUSE button can be pressed more than once to create a longer pause.

HOLD BUTTON

1.To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button located at the top right NOT the HOLD button located at the bottom left. The HOLD button located at the bottom of the phone should only be used when the phone is not connected to a phone system.

2.To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after putting a call on hold, the phone will ring back within 60 seconds. Answer the phone and you will be connected to the caller.

HOLD/FLASH BUTTON

This telephone provides a line break signal for putting callers on hold or to transfer calls.

1.To place a call on hold using TalkSwitch, be sure to use the HOLD/FLASH button located at the top right not the HOLD button located at the bottom left. The HOLD button located at the bottom of the phone should only be used when the phone is not connected to a phone system.

2.To retrieve a caller simply press HOLD/FLASH + ‘7’. If you hung up the phone after putting a call on hold, the phone will ring back within 60 seconds. Answer the phone and you will be connected to the caller.

Flash can also be used when storing numbers in memory locations when Direct Line Access has been enabled on Local Extensions connected to TalkSwitch.

TS-100 Owner’s Manual 6