TANDBERG PrecisionHD 1080p/720p camera | Camera User Guide |
Contentsontents
IntroductionIntroduction
PhysicalPhysicaliinterfacet rf
Cablesables
ConnectiConnect toto codec
Videoideo forformatsats
Daisyaisy chainingchaining
AppendicesApp dicesices
Contactontact usus
The VISCA™/RS–232 control protocol, cont...
Network and interface commands
Command set | Command packet | Comments | |
IF_Clear | 8x | 01 00 01 ff | Clear command buffer. Stop any |
|
|
| current operation in progress. Does not |
|
|
| do much on Rover. |
Address_Set | 8x | 30 0p ff | p = address for this device. If x=8 |
|
|
| (broadcast), increase p with 1 before |
|
|
| sending to chain. |
Command_ | 8x | 2p ff | p = Socket ID. Rover does not support |
Cancel |
|
| multiple sockets. Commands will |
|
|
| always run to completion. Don’t use it |
Push messages
Messages sent from camera to controller.
Command set | Command packet | Reply and comments |
Network_ | y0 38 ff | This indicates that cameras have been added |
Change |
| to or removed from the chain. |
|
| It is recommended to wait 9 seconds after |
|
| receiving this message before doing a full |
|
| reconfigure. |
IR_Push | y0 07 7d 02 gg hh ff | If IR mode is on, IR codes received by the |
|
| camera will be sent to the controller. |
|
| gg = IR ID |
|
| hh = keycode |
22 | www.tandberg.com |
