Tandberg Data 2U LTO quick start Before you begin, Unpacking, Lift unit only by the 2 sides

StorageLoader 2U LTO Quick Start Guide

Step 1 — Before you begin

1 — Ensure that you have all the required items before you proceed (see Accessories and Additional Items on page 1).

2 — Locate an appropriate area for the unit that has adequate clearance for ventilation, minimal dust and debris, and an appropriate power source. The unit is designed for installation in a standard 4 post, 19-inch rack.

3 — Ensure that the work area is free from conditions that could cause electrostatic discharge (ESD). Discharge static electricity from your body by touching a known grounded surface, such as a computer’s metal chassis.

4 — The unit must be operated in the horizontal position. Do not place it on its side, and do not place objects on top of it.

Step 2 — Unpacking

1 — Remove foam and accessories:

LVD SCSI cable and terminator*

Barcode labels and warranty

Ethernet cable Power cables

Rack mount kit

2 — Lift unit only by the 2 sides

•LVD SCSI configuration only

Important: Save all original packing materials in case you need to ship or move the library later.

Step 2a — Rack-mounting (optional)

If you plan to install the library in a rack, see the Rack-mount Instructions (complete prior to Step 3).

WARNING! Before performing any installation or maintenance procedures, be sure that the library power switch is in the off position and that the power cord is disconnected from the library and the outlet.

WARNUNG! Vor der Ausführung von Installations- oder Wartungsarbeiten ist darauf zu achten, daß der Library-Netzschalter auf “Aus” gestellt ist und daß das Anschlußkabel vom Library und der Steckdose entfernt ist.

¡PRECAUCIÓN! Antes de realizar cualquier procedimiento de instalación o de mantenimiento, comprobar que el interruptor de alimentación de la biblioteca está apagado y que el cable de alimentación no está enchufado ni a la biblioteca ni a la toma de corriente.

Step 3 — Connecting the cables

SCSI connections (LVD only):		Fibre Channel connections:
1 — Connect SCSI cable S and Terminator* T 2 — Connect Power cord		1 — Connect Fibre Channel cable FC 2 — Connect Power cord
E	P	E	P

T

S

FC

P Power switch (Off=0 On=I ) E Ethernet port (see Product Manual for addressing; the default setting is DHCP enabled)

Important: Both LTO-2 and LTO-3 tape drives require Ultra 160 rated SCSI cabling, and an Ultra 3 or LVD 160 Active SCSI terminator to function properly on the SCSI bus. An inadequate terminator will result in various SCSI bus issues, including bus hangs and Read/Write failures. See the “Troubleshooting” chapter of the Product Manual for additional information.

Page 2 of 8