Pioneer DVR-650H-K Repairing disc, Repairing the HDD, Could not repair the disc, This unit

15Additional information

Message	Explanation/Action
• Repairing disc.	During recording, the power was cut. This display
• Repairing the HDD.	appears when the power is restored.
• Could not repair the disc.	The recorder was unable to repair the disc after a
	power cut. The contents of the recording will be
	lost.

•Overheating has stopped operation. Press DISPLAY to clear message.

The internal temperature of the recorder has exceeded the operating limit. If this message reappears, please ask your nearest Pioneer- authorized service center or your dealer to carry out repairs.

•HDD optimization is recommended. This can be done using Disc Setup.

The HDD should be optimized (basically, HDD housekeeping) to maintain playback and recording performance.

•Please perform HDD optimization. The HDD is in more urgent need of optimization in

This can be done using Disc Setup.	order to maintain performance.
• The HDD has not been sufficiently	If this message appears repeatedly after
optimized. Please optimize again.	optimizing the HDD it is likely that there is not
	enough free space on the HDD for optimization to
	complete properly. Please erase some titles from
	the HDD and optimize again.

•An error occurred. Please consult the This message is displayed when information from

service center. Note that contents on	the HDD cannot be read. The HDD may be
the HDD may be erased when servicing	damaged or broken. Please ask your nearest
this unit.	Pioneer-authorized service center or your dealer to
	carry out repairs.

•The Hard Disk Drive info is incorrect. As the HDD info cannot be properly read, no new Use the Disc Setup menu to reinitialize. recordings can be made. Reinitializing the HDD

(page 100) may result in your being able to make recording again. Note that reinitializing the HDD will erase all recorded contents, including protected files.

•There is no DV input or the input signal is unrecordable.

No signal was detected at the DV IN jack. This may appear if a blank section of DV tape is playing in the connected camcorder.

• No DV camcorder connected.

The camcorder is not connected properly, or the camcorder is switched off.

•You cannot connect more than one This recorder’s DV jack supports connection to

DV camcorder at a time. just one camcorder.

•Cannot operate the DV camcorder. This recorder cannot operate the DV camcorder. Try switching off the camcorder then turn it back on again.

122

En