Pioneer DVR-650H-K operating instructions Playing CDs and WMA/MP3 discs, Except WMA Press to start

Playback 06

PREV NEXT Press to skip to previous/next chapter/title. (During playback you can also use the front panel

CH +/– buttons.)

Except WMA: Press to start

scanning. Press again to

increase the scanning speed.

(There are two scan speeds; the

current scan speed is shown

ABC DEF

GHI JKL MNO

PQRS TUV WXYZ

CLEAR

ENTER

During playback, enter a title number then press ENTER to skip directly to that title.

Press CLEAR to clear a number entry and start again.

		on-screen.)
		Press to skip to previous/next
PREV	NEXT
		track (or folder for WMA/MP3
		disc). (During playback you can
		also use the front panel CH +/–
		buttons.)
		During playback, enter a track
ABC	DEF

				(Commercial back/skip) Each
CM		CM		press skips backward/forward
BACK		SKIP		progressively up to a maximum
				of two hours in either direction.
			While paused, press and hold
	/	/
				to start slow-motion playback.
				Press repeatedly to change the
				playback speed.
				While paused, press to advance
				a single frame in either
				direction.

Playing CDs and WMA/MP3 discs

The table below shows the basic playback

controls for audio CDs1, and WMA/MP3 files.

PLAY Press to start playback.

STOP Press to stop playback.

PAUSE Pauses playback, or restarts

playback when paused.

GHI	JKL	MNO number then press ENTER to
		skip directly to that track.
PQRS	TUV	WXYZ
		Press CLEAR to clear a number
		CLEAR
		entry and start again.
		ENTER

Playing Video CD

The table below shows the basic playback controls for Video CDs.

Some discs feature Playback Control (PBC for short) menus. These discs show PBC in the display when you load them and display a menu on-screen from where you can select

what to watch.2

PLAY	Press to start playback.
	If RESUME is displayed on-
	screen, playback starts from
	the place last stopped.
STOP	Press to stop playback.
	You can resume playback from
	the same point by pressing
	PLAY. (Press STOP again
	to cancel the resume function.)
PAUSE	Pauses playback, or restarts
	playback when paused.

Note

1If you want to play a DTS audio CD, make sure the recorder is connected to a DTS-compatible amp/receiver with a digital connection. Noise will be output through the analog outputs. Also make sure that STEREO is selected using the AUDIO button (see Switching audio channels on page 60).

2When playing in PBC mode, some playback features, such as search, repeat and programme play are not available. You can play a PBC Video CD in non-PBC mode by starting playback using the Disc Navigator (see Using the Disc Navigator with playback-only discs on page 56).

53

En