Tandy 16-289 owner manual Using the Remote Control, Channel Selection Number But

16-289.fm Page 10 Tuesday, July 20, 1999 10:57 AM

USING THE REMOTE CONTROL

The remote control has the same con- trols as the TV’s front panel, as well as the additional controls described in this section.

To operate the remote control, point its front window toward the TV’s front panel. Then press the desired but- ton(s) on the remote control.

Channel Selection Buttons

10

Channel Selection (Number) But-

tons — Press to directly select a chan- nel. The selected channel number appears on the screen for about 5 sec- onds.

•To select a single-digit broadcast (AIR) channel — Channel 5, for example — press 5. You do not need to press 0 before entering a single-digit channel (but, if you do, the TV changes channels faster).

•To select a double-digit broadcast channel — Channel 12, for exam- ple — press 1 and then 2.

•To select a three-digit cable chan- nel — Channel 121, for example

— press 1, 2, and 1.

Note: You must select CABLE as the input source before you can select a cable channel. See “Se- lecting the Input Signal” on Page 12.

RECALL — Displays the current chan- nel number for about 5 seconds. Also clears the on-screen function displays.

SLEEP — Sets the sleep timer.

PICTURE — Selects a picture control (contrast, brightness, color, tint, or sharpness) for adjustment.

TV/VIDEO — Selects the TV or VIDEO mode.

CAPTION — Turns the closed caption decoder on or off.