Tannoy CMS801 PI, CMS801 DC PI, CMS801 DC BM, CMS801 sub BM, CMS801 sub PI installation manual Cms

CMS	5.3 MECHANICAL INSTALLATION INSTRUCTIONS FOR OPTIONAL PLASTER RING:
	An optional plaster (mud) ring bracket is available from Tannoy. This bracket is designed to be pre-installed into newly
	constructed, non-suspended ceilings.
		1	Nail or screw the plaster ring to the joists.

5.4 INSTRUCTIONS FOR OPTIONAL PRE-INSTALLATION BACK CAN (PI MODELS ONLY):

AN OPTIONAL PRE-INSTALL BACK CAN IS AVAILABLE FOR ALL PI (PRE-INSTALL) MODELS. THIS BACK CAN IS DESIGNED TO BE PRE-INSTALLED INTO NEWLY CONSTRUCTED, NON-SUSPENDED CEILINGS.

Note that the CMS801 PI model’s transformer is pre-attached to CMS801 PI back can for easy install.

1Attach the back can to the installed conduit This can be attached in two ways:

2Lay the speaker wiring to where the speaker will be fitted and complete the plastering work on the ceiling.

3Cut out the hole in the ceiling using a circular saw or pad saw.

a. You can use the clamp at the back of the pre-install back can. The product will accept a squeeze connector with a thread size of up to 22mm: To remove the cable clamp, simply unscrew the threaded washer (under the wiring cover) which holds the cable clamp in place and replace it with a conduit squeeze connector.

b. You can use any of the three knock-out points at the sides of the PI back can (19mm, 22mm or 28mm diameter):

Conduit

Conduit Squeeze Connector

4Go to section 6 for instructions on wiring then return to point 5 below.

5	Slide the speaker assembly through the hole and turn the screws to extend the mounting
	wings. Tighten the screws until a firm grip is achieved.
	If using a power driver, Tannoy recommends a torque setting of 1.5Nm.
	DO NOT OVERTIGHTEN!

6Insert grille by pushing it onto the speaker.

2Lay the speaker wiring to where the speaker will be fitted and complete the plastering work on the ceiling.

3Cut out the hole in the ceiling using a circular saw or pad saw

4Go to section 6 for instructions on wiring and setting up then return to point 5 below.

5Slide the speaker assembly through the hole and turn the screws to extend the mounting wings. Tighten the screws until a firm grip is achieved.

If using a power driver, Tannoy recommends a torque setting of 1.5Nm.

DO NOT OVERTIGHTEN!

8

9