Tape CUE | Tascam 424MKIII instruction

Track 1 playback through TAPE CUE

Switching TAPE CUE on					1. Set the EFFECT 2/TAPE CUE selection switch located below the
					LEVEL control to the right/TAPE CUE position.

Monitor selection

2.Slide the MONITOR SELECT LINE OUT switch to the center MONO position.

Locating tape to zero

3.Press the RTZ key. The tape will rewind, automatically stopping at the zero counter point.

Begin to play

4.Press PLAY.

Listening level adjustment

5.Turn the MONITOR LEVEL control up or down to the desired listening level.

Routing tape signals to

TAPE CUE

6.Locate the EFFECT 2/TAPE CUE level control on channel 1 and slowly turn it to the right. You'll hear, in center mono, what you have recorded on track 1.

Stop play

7.Press STOP to stop play.

18

Image 16

Tascam 424MKIII owner manual Tape CUE

Contents

424@$ Table Of Contents Safety Instructions Portastudio 424 Mkiii is IntroductionAbout the weld line Recording System Three Steps to Multitrack Signal Flow in the 424 Mkiii Mixer Understanding the Mixer Tape Cue Monitor System Multitrack Cassette Recorder Rehearsal Tape Speed and Track Format Track Format and Tape RecommendationsTape Type Accidental Erase/Record Protection Tape Length Portastudio 424 Mkiii Brief Guide Portastudio 424 Mkiii Brief Guide Recorder Controls Rear Panel Connections Step-By-Step-Operations Guide Page Page Tape CUE Page How to record many sources onto a single track How to record a mix onto two tracks simultaneously Recording on more than two tracks simultaneously Direct Page Using channels 5 and 6 with alternative inputs at mixdown Review Record level Loading Memo points Using Memory Location PointsMemo Locating the tape To zero To Memo Auto play Operating procedure To interrupt Repeat sequence Repeat Play PUNCH-IN or Insert Recording Preliminary Selecting in and out pointsPage Actual Auto Punch In/Out Auto Review Manual Punch-in Punching-in/out with Record Using the remote footswitch RC-30P Ping-pong procedure Bouncing Tracks Ping-PongPage Setting the output level of effect devices Using Effects With the Portastudio 424 MkiiiSetting the mix/balance control on effect devices How to Connect Your Effects Devices Syncing MIDI-Tape−Using the Tascam MTS-30 TroubleshootingProblem Possible Cause Problem Solution Features and Controls Power switch on the rear panel TurnsInput select switches Channels Channels 5 Stereo Input Section Mkiii Recorder Transport Controls Play key Displays Page Optional Accessories Care and Maintenance CleaningCleaning the Heads and Tape Guides Degaussing Demagnetizing Cleaning the Pinch Roller Cleaning the Capstan ShaftHow the dbx Works Degaussing the Tape Path Specifications High Effect 2 SEND/TAPE CUE OUTNormal Europe USA/CANADAAustralia Block Diagram Level Diagram 424@$