3 – Features and controls—Rear panel features
18 TASCAM CD-RW402 Owner’s Manual
Rear panel features
Digital connections These connections all han-
dle digital audio I/O.
kCOAXIAL INPUT and OUTPUT
(DRIVE 2) These RCA connectors accept and
transmit digital audio data to and from drive 2
respectively in SPDIF format.
The IN connector accepts AES3-1992 (TYPE I) as
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1kHz.
lOPTICAL INPUT and OUTPUT
(DRIVE 2) These TOSLINK-type optical connec-
tors accept and transmit digital audio data to and
from drive 2 respectively in SPDIF format.
The IN connector accepts AES3-1992 (TYPE I) as
well as SPDIF (TYPE II) format data. The unit auto-
matically detects the data type. Input may be from
32 kHz to 48 kHz, and output is always at 44.1kHz.
mCOAXIAL OUTPUT (DRIVE 1) This
RCA connector outputs digital audio data from drive
1 in SPDIF format.
nOPTICAL OUTPUT (DRIVE 1) This
TOSLINK-type optical connector outputs digital
audio data from drive 1 in SPDIF format.
Analog connections These connections all han-
dle analog audio I/O.
oUNBALANCED INPUT (2) These unbal-
anced RCA connectors allow the input of –10dBV
nominal level signals to drive 2 (red=right).
pUNBALANCED OUTPUT (2) These
unbalanced RCA connectors output the signal from
drive 2 at –10dBV nominal levels (red=right).
qUNBALANCED COMMON OUT These
connectors are used in the same way as the
COMMON setting for the headphone monitoring D.
Drive 1 takes priority if both drives are playing, oth-
erwise the currently-playing drive takes priority
(red=right).
rUNBALANCED OUTPUT (1) These
unbalanced RCA connectors output the signal from
drive 2 at –10dBV nominal levels (red=right).
sBALANCED INPUT [L, R] (2) These bal-
anced XLR-type female connect ors accept analog
signals at +4 dBu nominal levels to drive 2.
tBALANCED OUTPUT [L, R] (2) These
balanced XLR-type male connectors output the ana-
log outputs from drive 2 at +4dBu nominal levels.
uBALANCED OUTPUT [L, R] (1) These
balanced XLR-type male connectors output the ana-
log outputs from drive 1at +4dBu nominal levels.
NOTE
All XLR-type connectors are wired with 1=ground,
2=hot, and 3=cold.
Other connections These are control and power
connections.
vCONTROL I/O This connector allows for
remote control and fader stop/start control of the
kl mnopqr s t u
vw x