5 - Messages, troubleshooting, etc.
5.1.1 Self-diagnostic program
The
1Eject and remove any disc, and turn off the
2Press and hold down the PLAY and STOP keys on the main unit ([15] and [14]) and keep them pressed while turning the unit back on again.
3The display will show the word BUSY, in flashing characters, after a few seconds.
4After a few minutes, the message will change to either ERROR or PASSED.
5If the ERROR message appears, there is a fault in the
6If the PASSED message appears, the prob- lem is one which cannot be diagnosed by the program. The problem may be due to any of the following causes: you are trying to do an operation which does not correspond to the instructions in this manual, the disc is of the wrong type for the operation, the connections have been wrongly made, or there may be a fault in the mechanical part of the recorder.
7Leave the