By connecting an iPod with the iPod dock on the front panel, this unit can control the iPod and output its sound/ video. Moreover, it can also recharge the iPod when this unit’s power is ON.

iPod dock

Connect an iPod following the instructions on page 16. Always attach a dock adapter suitable for your iPod to the connector. Dock adapters are not included with this product. Use the dock adapter included with your iPod or a commercially available Apple iPod Universal Dock Adapter made by Apple Inc.

•• Read the instructions on page 16 carefully and proceed with caution in order to avoid damage to the connectors and sudden bursts of noise when connecting and disconnecting an iPod.

•• See our website (http: //www.tascam.com/) for information about compatible devices.

Controlling an iPod

The following keys on the CD-200i front panel and remote control (RC-CD200i) can be used to control the iPod.

PLAY/READY key (¥/π): Play/Pause

STOP key (ª): Pause

SKIP keys (Ô/Â, ¯/): Previous and Next (press and hold for Rewind and Fast-forward)

FOLDER keys (˙/¥): Skip through albums

REPEAT key: Cycle through repeat single track, repeat all tracks and repeat off modes

PLAY MODE key: Cycle through continuous, song shuffle and album shuffle playback modes

DISPLAY key: Sets whether the iPod video is shown on the iPod itself or output from this unit’s VIDEO OUT jack

CAUTION

Depending on the iPod software version, operation from the CD-200i might not work.

Settings made on the iPod

Make the following settings on the iPod in order to output video. These settings cannot be made from the CD-200i.

•• TV Signal setting (NTSC or PAL)

•• TV Screen (or Widescreen) setting

iPod playback

1.Press the PLAY MODE/INTRO CHECK (SOURCE SEL) while pressing and holding DISPLAY (SHIFT) key at the same time, or press the SOURCE SEL on

5 − iPod Playback

the remote control, and set the output sound source to iPod.

PLAY MODE/INTRO CHECK (SOURCE SEL) key

SOURCE SEL key

Doing this makes it possible to control the iPod from the CD-200i front panel and remote control (RC-CD200), as well as to output the iPod’s sound and video signals.

Setting the iPod video output

When iPod is selected, you can use the DISPLAY key on the main unit or the remote control to switch whether its video is shown on the iPod itself or output through this unit’s VIDEO OUT jack.

You cannot, however, switch the video output destination during video playback. Switch it while the iPod is stopped or stop the playback once and then switch it if the iPod is already playing back.

If switched during video playback, the new output destination is used when playback is stopped then started again.

[Video Out: iPod]

[Video Out: CD-200i VIDEO OUT]

•• When VIDEO ON is selected, the iPod video signal is always transmitted from this unit’s video outputs, regardless of the selected (audio) output source.

•• When playing the video clip by iPod Touch, pressing the DISPLAY key stops the video playback.

TASCAM CD-200i 31