SECTION 5: PLAYBACK I 5-5. Repeat Play You can have the DA-38 play between two MEMO points
over and over again.
If yoke haven’t done yet, create a play loop (as discussed
above) before proceeding with the following steps.
1 Press REPEAT. (You don’t need to press PLAY.)
0 As you press REPEAT, the DA-38 will start playing
upon locating the start point of loop. When played
up to the end of loop, the tape will automatically
rewind and start playing from the starI point again.
. Pressing STOP interrupts repeat play. To resume
repeat play, press PLAY.
0 You can change the current MEMO points during
the repeat play process. The repeat play will be
disabled if you happen to change the MEMO points
to create a loop shorter than 5 seconds.
* To exit the repeat play mode, press REPEAT. ‘Ibe
associated LED will then turn off and the transport
will go into
Normal play mode - if REPEAT was pressed
when the tape was playing,
NOTES
l There must be at /east 5
seconds between two
MEMO points.
. /f only ona MEMO point is set, play will repeat
between 00 00 00 00 and that MEMO point.
. The DA% understands the lower MEMO point as
the stati point of loop, and the higher point as the
end.
l if you press a transport control key during the
repeat play process, the function pressed is acti-
vated, but the repeat play mode is not disabled. To
resume repeat p/ay :
CI Press either LOG key and then, while the tape is
being autolocated or after completing autoloca-
tfon, press PLAK or
o Press PLAY when you are somewhere in the
repeat loop or before the start point of loop.
Stop - if REPEAT was pressed when the tape was
being located to the start point of loop.
s.4