SECTlON4: RECOROING 6 When the point where yo” want to punch out of
record is reached, press PLAY.
That point is saved to memory ; and the RHSL LED
that was blinking glows solid to show that the “nit is
now in Rehearsal mode,,
After about 3 seconds of play (this post-roll time is
adjustable, as discussed later), the tape will rewind,
automatically stopping at a point about 5 seconds
lower than the punch-in point (this pwmll time also
is adjustable, as discussed later).
n 7 To cycle over a seq”ence punching in and o”t, press
PLAY.
During Rehearsal mode, the monitor is automatically
switched from tape to input at the punch-in point and,
at the punch-out point, reverts to tape.
* If yo” decide to exit the Rehearsal mode, press
CLEAR. The RHSL LED will then turn off.
8 Repeat the rehearsal as many times as necessary. If
yo” are not satisfied with the c”rrent punch-in and o”t
point settings, first exit the rehearsal mode by press-
ing RHSL, then go back to step 3. Consider also the
possibilities explained under the next paragraph, (2)
Setting Punch I” and Out Points.
0 Auto Play Function : If yo” press PLAY during the
n autolocate process after p&roll, the PLAY button will
start brinking to show that the DA-38 will automatically
start playing when completing autolocation.
If yo” are “sing the optional RC-848 remote control
“nit and press its AUTO PLAY key, the trial punch-in
will automatically repeat over and over.
l If yo” are “sing the optional RC-30P footswitch, press
the footswitch in step 7, instead of PLAY.
(2) Setting Punch In and Out Points
You cm set the punch in and o”t points in my of three
ways :
A. Perform a trial punch-in recording in Reheaal mode,
as explained above.
B. Key in the desired points at men”s in Rehearsal
mode.
C. Perform a normal recording (as explained earlier, the
point yo” start recording from and the point yo” stop
recording are automatically stored into memory as
punch in and out points).
Punch in and out points yo” select by Method A or C can
be recalled from memory onto the display, and yo” can
trim them to frame acc”racy (Method B). Also, if the
necessary punch in and out points are known to yo” in
advance, yo” can directly enter them at men”s.
Follow these steps to control the punch in and out points
from nIe”“s :
f Check to see that the RHSL LED is lit. If it isn’t, press
the RHSL key two times and the LED will light.
2 Press SHIFT and the associated LED will stati blink-
ing to show that all the double function keys are
switched to offer their lower blue-labelled functions.
4-5