SECTlON6:AUTOLOCATlON This section of the manual provides infomation on
autolocation procedure, along with autolocation preroll
setting and auto play procedures.
6-1. Autolocatino to Either of Two Location
Points
You can have the DA-38 autolocate to either MEMO 1 or
MEMO 2 points.
We suppose yen have already set one or two MEMO
points. Setting locations is explained in Section 5.
f Simply press LOC I to have the DA-38 autolocate to
the location currently stored into the MEMO I aegis-
ter, or press LOC 2 to have the unit autolocate to the
current MEMO 2 location.
Upon pressing either LOC, the corresponding MEMO
point will show on the display before autolocation
stats.
0 You can have the DA-38 autolocate to a lower point
than predetermined location points, a.s discussed
below.
1 6-2. Settino Autolocation Preroll Time 1
The DA-38 is factory preset to autolocate directly to
MEMO points. But you can have the unit offer preroll
(up to 59 minutes, 59 seconds) to those points.
MEMO 1 MEMO 2
I AutolocatIon Pwroll
l The autolocation preroll is independent of the punch-in
preroll explained in Section 4.
,-Y
32
f
2
3
4
Press SHlFT and the associated LED will start blink-
ing to show that all the double function keys are
switched to offer their lower blue-labelled functions.
Press PRE ROLL and the current preroll time shows
on the display, like this :
Enter the desired preroll time by means of the A and
y keys.
l If you hold either the A or the V key and press the
other, the display is cleared to “flt7Gc”.
When the display shows the correct preroll time, press
SHIFT, and its associated LED will turn off, the
display being switched back to show the ABS time.