12 – Maintenance and settings–User setups in RAM
TASCAM DA-98HR 85

12.4 User setups in RAM

Commonly-used setups are saved in one of three user
setup memory banks: 1, 2 or 3. This enables pre-con-
figuration of the DA-98HR for different jobs (video
or film post-production, or different recording setups,
for example). There is also a preset memory bank
which contains the factory settings (see below).
When the DA-98HR is shipped, the contents of all
setup memories are the same; they contain the fac-
tory settings.

12.4.1 Saving user setups

1Go to menu group 9, move the cursor to
Setup and press ENTER:
2To save the current setup, press the § key
while the word Load is flashing so that the
bottom line now reads Save:
3Move the cursor (Ó and Á keys) to 1, 2 or
3, and press the § key:
4To save the current setup to the selected setup
memory, press the ENTER key.
The word Complete appears on the
screen for about 2 seconds and the user settings
are saved to the selected setup memory bank.

12.4.2 Loading user setu ps

1Go to menu group 9, move the cursor to
Setup and press ENTER:
2To load the setup memory into the current
memory, make sure the bottom line shows
Load:
3Move the cursor to 1, 2 or 3, and press the §
key:
4Press ENTER. The word Complete
appears on the screen for about 2 seconds. The
contents of the currently-selected setup are
loaded into memory and the unit resets itself.
NOTE
Since the unit resets when a user memory is loaded, you
should make sure that the levels of all monitoring equip-
ment, etc. are turned down, to avoid “thumps” and possible
damage to ears and equipment.

12.4.3 Resetting the memory to factory

defaults

You may sometimes want to reset all of the memory
to factory settings. The values of all the factory set-
tings are listed in 11, “Menu and parameter refer-
ence”.
1Follow the instructions regarding loadi ng user
setups, but choose F as the memory to load.
2Press ENTER. The word Complete
appears on the screen for about 2 seconds. The
factory settings are loaded into memory and
the unit resets itself.
Setup
Load 123F
Setup
Save 1 2 3
Setup
Are you sure?
3
Save 1 2
Setup
Load 123F
Setup
Load 1 2
3
F
Setup
Are you sure?
1
Load 2 3 F