7–Playback

Loop playback (I/O LOOP)

You can set an IN point (starting point) and OUT point (ending point) within a file and play the part

of the file between these points repeatedly.

1When the Home Screen is open and the track is playing or paused, press the I/O LOOP key at the position where you want the loop to start to set the IN point.

2When the track is playing or paused, press the I/O LOOP key at the position where you want the loop to end to set the OUT point.

3After setting both the IN and OUT points, loop playback starts automatically.4Press the STOP (ª) key to stop loop playback.

You can also press the PLAY/PAUSE (¥/π) key to restart playback from the endpoint.

NOTE

•You cannot set the IN and OUT points in different files.

•IN and OUT point settings are lost when you select a different file.

•If you press the I/O LOOP key when IN and OUT points are already set, their settings will be erased.

•Setting accurate IN and OUT points might not be possible with Variable Bit Rate (VBR) format MP3 files.

Adjusting the playback speed (PB

CONTROL)

You can adjust the playback speed by up to -50% or +16% of the original value. When doing so, it is possible to change the pitch with the speed or maintain the original pitch.

36 TASCAM DR-100

1When the Home Screen is open, press and hold the PB CONTROL key to open the PB CONTROL screen.

2Set the VSAitem to ONor OFF. When Variable Speed Audition (VSA) is ON, pitch does not change even when the speed is changed. When OFF, the pitch changes with the speed.

3Use the SPEEDitem to adjust the playback speed.4Press the HOME key to return to the Home

Screen.

5Press the PB CONTROL key briefly to turn this function ON and OFF.

NOTE

You can also turn PB CONTROL ON and OFF from the PB CONTROL screen.

Adjusting the playback volume

The volume output from the built-in speaker or the connector can be adjusted by using the /SP

OUTPUT dial.