11
Model 142 Operating Procedures
120501
Step 4
Slide the front bearing over the baffle rod s o the
flanged edge is against the door. Place the white
plastic guide bearing on the end of the baffle rod. Do
not lubricate the frontbearing or guide bearing.
Figure 8
Step 5
Insert the handscrews into the slots in the f reezer door.
With both hands holding the sides of the f reezer door,
insert the baffle rod into the center of the beater
assembly.T he white guide bearing must fit securely in
the hole of the drive shaft.
Step 6
Finger- tighten the handscrews, making sure they are
tightened equally and that the door is snug. Do not
over- tighten the handscrews.
Figure 9
IMPORTANT! Handscrew and door damage can
result if the handscrews are over -tightened o r if
one handscrew is tighten ed more than the other.
Step 7
Install the draw valve. Slide the two o- rings into the
grooves on the draw valve and lubricate with Taylor
Lube.
Figure 10
Lubricate the inside of the door spout from the botto m.
Insert the draw valve into the freezer door fr om the
bottom.
Figure 11