21
Model 142 Troubleshooting Guide
Section 8 Troubleshooting Guide

PROBLEM PROBABLE CAUSE REMEDY PAGE

REF.

1. No pr oduct being
dispensed.
a. Toggle switch in OFF
position.
a. Place toggle switch in the
AUTO position.
15
b. Inadequate level of mix in
mix hopper.
b. Fill mix hopper with mix. 15
c. Beater motor overloaded. c. Place the toggle switch in
the OFF position. Allow
the motor to cool. Reset
beater motor. Place the
toggle switch in the AUTO
position.
8
d. Unit unplugged at wall
receptacle.
d. Plug in power cord. ---
e. Tripped circuit breaker or
blown fuse.
e. Place the circuit breaker in
the ON position or replace
fuse.
---
f. Freezer door was
assembled incorrectly.
f. See “Operating
Procedures” for proper
installation.
10
g. Product is being drawn off
far in excess of freezer’s
capacity.
g. Stop drawing product and
allow unit to recover.
---
h. Feed tube incorrectly
installed.
h. Install feed tube according
to instructions in this
manual.
16
2. M achine will not operate in
the AUTO position.
a. Unit unplugged. a. Plug in power cord. ---
b. Circuit breaker tripped or
fuse blown.
b. Place the circuit breaker in
the ON position or replace
fuse.
---
c. Beater motor overloaded,
causing a loss of power to
the toggle switch.
c. Place the toggle switch in
the OFF position. Allow
the motor to cool. Reset
beater motor. Place toggle
switch in the AUTO
position.
8
3. P roduct is too stiff. a. The t emperature control is
set too cold.
a. Call service technician. ---