Taylor C713 Brush Cleaning

Model C713 Operating Procedures

Brush Cleaning

Step 1

Prepare an approved 100 PPM cleaning solution

(examples: 2-1/2 gal. [9.5 liters] of Kay-5Ror 2

gal. [7.6 liters] of Stera-SheenR). USE WARM

WATER AND FOLLOW THE MANUFACT URER'S

SPECIFICATIONS. Make sure all brushes provided

with the freezer are available for brush cleaning.

Step 2

Thoroughly brush clean all disassembled parts in the

cleaning solution, making sure all lubricant and mix

film is removed. Be sure to brush all surfaces and

holes, especially the holes in the freezer door.

Step 3

Rinse all parts with clean, warm water. Place the

parts on a clean, dry surface to air dry overnight.

Step 4

Return to the freezer with a small amount of

cleaning solution. Using the black brush, clean the

rear shell bearing at the back of the freezing

cylinder.

Figure 54

Repeat these steps on the other sid e of the

machine.

Step 5

Wipe all exterior surfaces of the freezer wit h a clean,

sanitized towel.

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Water Connections Electrical Connections Beater Rotation Refrigerant Section 2 To the Operator Compressor Warrant y Disclaimer Section 3 Safety To Operate Safely: S Page Page 9 Model C713 Operator Parts Identificati on C713 Exploded View Parts Identification 10 Model C713Operator Parts Identificatio n Model C713 Door and Beater Assembly Figure 2 Accessories Brushes Section 5 Important: To the Operator Symbol Definitions Power Switch Fluorescent Display Indicator Lights Standby Symbol Wash Symbol Auto Symbol Reset Mechanism Feed Tube Adjustable Draw Handle Operating Screen Descriptions Power Up Power Switch ON Brush Clean Counter Manager's Menu Entering Access Code Menu Options Page Faults Occurring While in AUTOMode Page Section 6 Operating Procedures Freezing Cylinder Assembly Page Page Page Page Sanitizing Priming Manual Brush Cleaning S S S S Draining Product From The Freezing Cylinder Rinsing Hopper Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide Page Page Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment Taylor Company Section 11 Limited Warranty on Parts Page Taylor Company 059899-27 FIG. 1 FIG .4 RED BLK 059899-33 GROUND FRAME SECURELY BLK PERSONALITY BOARD 0-12 AMP BEATER MOTOR AMPERAGE RANGE YES PERSONALITY BOARD 0-6 AMP BEATER MOTOR AMPERAGE RANGE NO 059899-40 FIG. 1 FIG .4 RED BLK 059899-58 GROUND FRAME SECURELY BLK PERSONALITY BOARD 0-12 AMP BEATER MOTOR AMPERAGE RANGE YES PERSONALITY BOARD 0-6 AMP BEATER MOTOR AMPERAGE RANGE NO