Manuals / Taylor / Lawn and Garden / Swimming Pool Heater

Taylor Pool Heat Pump Instrument Identification, Description Of Front Panel, Backwash Key

Models: Pool Heat Pump

1 28

Download 28 pages 48.72 Kb

Page 19

Image 19

1.INSTRUMENT IDENTIFICATION

HEAT ON LED

POOL or SPA

DIGITAL DISPLAY

F DEGREES LED

SET UP MODE LED

C DEGREES LED

SET-UP KEY

DECREASE KEY

INCREASE KEY

BACKWASH KEY	ON/OFF KEY

2. DESCRIPTION OF FRONT PANEL:

DIGITAL DISPLAY: Display normally shows the actual water temperature.

HEAT ON LED: Indicates that the heat pump is heating the pool or the spa.

°F LED: Indicates that the temperature is being displayed in °F.

°C LED: Indicates that the temperature is being displayed in °C.

SET MODE LED: Indicates the setup or adjustment mode.

ON/OFF KEY [%]: Turns the heat pump ON or OFF.

BACKWASH KEY [BACKWASH]: Hold for 3 seconds to activate the backwash mode.

SET KEY [SET]: Hold for 3 seconds to activate the setup mode.

INCREASE KEY [^]: Increases the desired or setpoint temperature.

DECREASE KEY [v]: Decreases the desired or setpoint temperature.

NOTE: The display may be changed in steps by pushing the [^] or [v] keys briefly, or automatically by holding down the same key.

Page 19

Image 19

Taylor Pool Heat Pump owner manual Instrument Identification, Description Of Front Panel, Backwash Key, On/Off Key

Contents

POOL HEAT PUMP OWNER’S MANUAL INSTALLATION MANUALREAD THESE INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR USING YOUR NEW POOL HEAT PUMPQuestions and Answers TABLE OF CONTENTSMaintenance WarrantyHow Does It Work? Low MaintenanceINTRODUCTION A Cost-efficient HeaterCP Model Air Supply and AccessibilitySELECTING THE LOCATION Other RecommendationsWATER INLET AND OUTLET CONNECTIONS Chlorinators, Brominators and Other Automatic Systems Basic ConnectionPressure-type Chlorinator or Brominator Salt Chlorinator In-line Chlorinator or BrominatorDual Unit Connection Using Independent Pumps and Filters for the Pool and the Spa Using One Pump and One Filter for the Pool and the SpaPOOL AND SPA CONNECTION ELECTRICAL CONNECTION Winterizing Titanium heat exchanger MAINTENANCECleaning Winterizing Cupro-nickel heat exchangerUnscrew brass cap Winterizing Titanium heat exchangerLoosen bypass valves Brass capWater Deviation Seasonal Start-upTable 1 Chemical Products Concentration in Pool Water Standard WATER MAINTENANCEWhy Perform Water Maintenance? Water ChemistryChemical Table 2 pH of Various Chemical Products for PoolsShock Treatment Sanitizers1 Trichloro-s-triazinetrione TCCA or trichlor or pucks 5 Salt Generated Chlorine 2 Bromine3 Sodium hypochlorite liquid chlorine 4 Calcium Hypochlorite granular or stick chlorine3 Protecting the Pool Heat Pump What to do?1 Testing 2 BalancingUSER GUIDE MANUAL HP706 SWIMMING POOL HEATPUMP CONTROLC LED Indicates that the temperature is being displayed in C HEAT ON LED POOL or SPA DIGITAL DISPLAY F DEGREES LED SET UP MODE LEDDIGITAL DISPLAY Display normally shows the actual water temperature F LED Indicates that the temperature is being displayed in Fd. TO VIEW THE DEFROST TEMPERATURE a. SWITCHING THE HEATPUMP ONb. SWITCHING THE HEATPUMP OFF c. TO VIEW THE SETPOINT OR DESIRED TEMPERATUREg. DEADBAND OR TEMPERATURE DIFFERENTIAL ADJUSTMENT TO ENTER THE SERVICE MODEe. DEFROST CUT-IN TEMPERATURE ADJUSTMENT f. DEFROST CUT-OUT TEMPERATURE ADJUSTMENTCODE ERROR CODE LISTSYMPTOM SOLUTIONPROBABLE CAUSE SYMPTOMSOLUTION CODEPossible Causes SOLVING PROBLEMSError Possible SolutionsQUESTIONS AND ANSWERS EXCLUSIVE LIMITED WARRANTY WARRANTYPOOL HEAT PUMPS Available only for brand new products purchased LIMITED WARRANTY5YEARS PARTS & 2 YEARS LABOR STARTING FROM THE INSTALLATION DATE POOL HEAT PUMPST.T.I 690, Place Trans-Canada Longueuil, QC, J4G 1P1