In-line Chlorinator or Brominator
| P-trap | Filter |
| Water pump |
| |
| Check-valve | |
| Chlorinator | |
The in-line chlorinator or brominator should be installed on the pool water return line, between the heat pump and the pool. This type of chlorinator (brominator) should be installed as far as possible from the heat pump. Install a check-valve between the heat pump and the chlorinator (brominator).
The p-trap should be installed higher than the top of the chlorinator (brominator) to prevent migration.
Salt Chlorinator
Salt chlorinators are made to be installed like in-line chlorinators. Therefore, they must be installed in accordance with the “In-line Chlorinator or Brominator” connection di- rectives, else the warranty of the heat pump will be voided. (See the section “Water Main- tenance” on p.12 and the section «Salt Generated Chlorine» on p.15 for more information on operating salt chlorinators.)
Dual Unit Connection
| | | | | For some larger pools, it may be nec- |
| | | | | essary to install two units in parallel. In this |
| | | | | case, double the distances recommanded in |
| | | | | the table 1 of the page 5. Never place two MP |
| | | | | models coil against coil, fan against fan or coil |
| 6 | | 6 | | against fan. |
| | | | | 1,2 and 3 : calibrated valves |
| 1 | 3 | 4 | | 4 | : filter |
| 5 | 5 | : water pump |
| 2 | |
| | | | | 6 | : flow meters |
When the access to a heat pump is shut off, the water flow passing through this heat pump will be redistributed among all others. Therefore, the valves mus be re-ad- justed to meet the water flow requirements.
