12 Model C707Important: Tothe Operator
130709
When the STANDBY key is pressed, the light comes
on, indicating the CTR (Cylinder Temperature
Retention System) has been activated. In the
STANDBY mode, the WASH and AUTO functions are
automatically cancelled. The MIX REF funct ion is
automatically locked in to maintain the mix in the
hopper.
To resume normal operation, press the AUTO key.
When the unit cycles off, the product in the freezing
cylinder will be at serving viscosity. At this time, place
the feed tube (end with the hole) into the mix inlet
hole and install the air orifice.
Figure 2
WASH K ey
When the WASH key is pressed, the light c omes on.
This indicates beater motor operation. The STANDBY
or AUTO modes must be cancelled first to activat et he
WASH mode.
AUTO Key
When the AUTO key is pressed, the light comes on.
This indicates that the main refrigeration system has
been activated. In the AUTO mode, the WASH or
STANDBY functions are automatically cancelled. The
MIX REF function is automatically locked in t o
maintain the mix in the mix hopper.
Note: An indicating light and an audible tone will
sound whenever a mode of operation has been
pressed. Toc ancel any function, press the key again.
The light and mode of operation will shut off.
Beater Motor Reset Button
The reset button is located on the left side of the unit.
The reset protects the beater motor f rom an overload
condition. If an overload occurs, the reset mechanism
will trip. Topr operly reset the freezer, press the AUTO
key to cancel the cycle. Turn the power switch to the
OFF position. Press the reset butt on firmly.
Do not use metal objects to p ress the reset
button. Failure to follow this instruction may
result in electrocution.
Turn the power switch to the ON position. Press the
WASH key and observe the freezer’s performance.
Open the side access panel. Make sure the beater
motor is turning the drive shaft in a clockwis e direction
(from the operator end) without binding.
If the beater motor is turning properly, press the WASH
keyto cancel the cycle. Press the AUTO key to resume
normal operation. If the freezer shuts down again,
contact a service technician.
Adjustable Draw Handle
The Model C707 features an adjustable draw handle
to provide the best portion control. The draw handle
should be adjusted to provide a flow rate of 5 t o 7-1/ 2
oz. of product per 10sec onds. ToINCREASE the flow
rate, turn the screw CLOCK WISE. Turn the screw
COUNTER- CLOCKWISE to DECREASE the flow
rate.
Figure 3