Taylor soft serve freezer

Model C707 Operating Procedures

140618

Step 7

Install the front drip tray and the splash shield under

the door spout.

Figure 17

Step 8

Slide two o- rings on one end of the feed tube. Slide

two o- rings on the other end of the feed tube.

Figure 18

Slide the small o- ring into the groove of the air orifice.

Do not lubricate the o- ring.

Figure 19

Note: Make sure the hole in the air orifice is clean and

is not clogged. If the hole in the air orifice should

become clogged, use soap and hot water to clear the

hole. Do not enlarge the hole in the air orifice.

Install the air orifice into t he hole in the top of the feed

tube (in the end without the small hole on the side).

Figure 20

Step 9

Lay the feed tube (with the air orifice installed) and the

hopper gasket in the bottom of the mix hopper for

sanitizing.

Step 10

Slide the rear drip pan into the hole in the side panel.

Figure 21

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Water Connections Electrical Connections Beater Rotation Refrigerant Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S 7 Model C707 OperatorParts I dentification 140618 Section 4 Operator Parts Identification Model C707 8Model C707Operator Parts Identificati on 140618 Model C707 Single Spout Door and Beater Assembly Brushes Section 5 Important: To the Operator Symbol Definitions Power Switch Indicator Lights MIX REF Key STANDBY Key WASH K ey AUTO Key Beater Motor Reset Button Adjustable Draw Handle Feed Tube Assembly Section 6 Operating Procedures Assembly Page Page Page Sanitizing Page Priming Closing Procedure S S S S S Draining Product From the Freezing Cylinder Rinsing Cleaning Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAG E REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany Section 12 Parts List Page Page Page Page Page Page Page Page 064288-27 FIG. 1 FIG. 5 FIG. 3 A A Model C707 064288-33 GROUND FRAME SECURELY UNDER PRIMARY SINGLE PHASING CONDITIONS COMPRESSOR AND BEATER MOTOR PROTECTEDCOMPRESSOR AND BEATER MOTOR PROTECTED UNDER PRIMARY SINGLE PHASING CONDITIONS Model C707 064288-40 FIG. 1 M FIG. 3 FIG. 2 064288-58 GROUND FRAME SECURELY UNDER PRIMARY SINGLE PHASING CONDITIONS COMPRESSOR AND BEATER MOTOR PROTECTED A A