Taylor soft serve freezer PROBLEM PROBABLE CAUSE REMEDY PAG E REF.

26 Model C707TroubleshootingGuide
PROBLEM PROBABLE CAUSE REMEDY PAG E
REF.
6. The drive shaft is stuck in
the drive coupling.
a. Rounded corners of drive
shaft, coupling, or both.
a. Call service technician to
correct cause, and to
replace the necessary
components. Do not
lubricate the hex end of
the drive shaft.
---
b. Mix and lubricant collected
in the drive coupling.
b. Brush clean the rear shell
bearing area regularly.
22
7. The freezing cylinder walls
are scored.
a. The beater assembly is
bent.
a. Call service technician to
repair or replace the
beater and to correct the
cause of insufficient mix in
the freezing cylinder.
---
b. The front bearing is
missing or worn on the
freezer door.
b. Install or replace the front
bearing.
15
8. Excessivemix leakage
into the rear drip pan.
a. Missing or worn drive
shaft seal on drive shaft.
a. Install or replace regularly. 14 / 27
b. The rear shell bearing is
worn.
b. Call service technician to
replace rear shell bearing.
---
9. Excessivemix leakage
from door spout.
a. Missing or worn draw
valve o- rings.
a. Install or replace regularly. 16 / 27
b. Inadequate lubrication of
draw valve o - rings.
b. Lubricate properly. 16
c. Wrong type of lubricant is
being used (example:
petroleum base lubricant).
c. Use the proper lubricant
(example: Taylor Lube).
14
10. No freezer operation after
pressing the AUTO key.
a. Unit is unplugged. a. Plug into wall rec eptacle. ---
b. The circuit breaker is off
or the fuse is blown.
b. Turn the breaker on, or
replace the fuse.
---
c. The beater motor is out on
reset.
c. Reset the freezer. 12
11. Product is not feeding into
the freezing cylinder.
a. Inadequate level of mix in
the mix hopper.
a. Fill the mix hopper with
mix.
20
b. The mix inlet hole is
frozen up.
b. The mix hopper
temperature needs
adjustment. Call service
technician.
---