Basic Operation 1
1 4
2 |
| 3 |
| 5 |
1Press the POWER switch.
The unit enters standby mode, and the standby indicator lights.
2Press the STANDBY/ON button to turn the unit on. The standby indicator goes off.
3Select a source by pressing one of the INPUT SELECTOR buttons.
The selected source is shown on the front panel’s display.
Each time the VIDEO button is pressed, the source changes as follows:
VIDEO 1 
VIDEO 2 
VIDEO 3 
Each time the AUDIO button is pressed, the source changes as follows:
CD 
AUX 
TAPE
Each time the FM/AM button is pressed, the mode changes as follows:
FM ST 
FM MONO 
AM
<If one of the INPUT SELECTOR buttons is pressed in the standby mode, the unit is turned on.
<If the source is connected to EXTERNAL IN jacks, press the EXTERNAL IN button and proceed to step 5 .
4When you selected VIDEO (1 or 2) or CD in step 3 , press the DIGITAL INPUTS button repeatedly to select the terminal.
o1: Select this when the source is connected to DIGITAL IN (OPTICAL) terminal.
c1: Select this when the source is connected to DIGITAL IN (COAXIAL 1) terminal.
c2: Select this when the source is connected to DIGITAL IN (COAXIAL 2) terminal.
A:Select this when the source is connected to analog AUDIO IN jacks.
<The DIGITAL indicator blinks when the unit cannot perceive the digital signal. In that case, connect a digital device to the DIGITAL IN terminal, switch it on, and select the terminal by pressing the DIGITAL INPUTS button.
<You can hear the sound from the selected DIGITAL IN terminal as far as VIDEO (1 or 2) or CD has been selected in step 3 .
5Play the source, and gradually turn up the volume to the required level by turning the MASTER VOLUME knob.
16
