Teac CD-RW900CD Playback modes, Continuous playback, Single-track playback, Program playback

4−Playback operations

Playback modes

There are four different playback modes. The selected mode will be indicated on the left of the display.

≠Continuous playback mode (default setting): no indi- cation lamp

≠Single playback mode: SINGLE lamp is lit

≠Program playback mode: PROGRAM red lamp is lit

≠Random playback mode: RANDOM red lamp is lit

The playback mode can be selected using the PLAY MODE key on the remote control unit. Pressing the key changes the playback mode on the display in the fol- lowing order:

Continue®Single®Program®Random

You can also select the playback mode using the PLAY MODE option in the PLAY sub-menu (refer to “Opera-

tion basics” on page 14). Turning the MULTI JOG dial clockwise changes the playback mode shown on the display in the following order:

Mode>Cont®Mode>Single®Mode>Program® Mode>Random

Pressing the MENU key or pushing the MULTI JOG dial returns to normal mode from the menu mode.

While the mode can be changed from any playback mode, the explanation in this manual will assume the user is starting from the Continuous mode.

NOTE

The selected playback mode remains after power is turned off. However, the setting of program playback mode will be deleted when power is turned off.

Continuous playback

Programing is cancelled, and playback continuous in the normal order.

1During stop, set the Continue or the Mode>Cont mode.

2Press the PLAY key to begin playback in order of the track number.

Single-track playback

This function enables playback of just a single track.

1During stop, set the Single or the Mode>Single mode.

2Use the SKIP key or the number keys (0~9) on the remote control to select the desired track.

The MULTI JOG dial can be used to select the track also.

3Press the PLAY key to begin playback.

After the selected track finishes, playback stops.

Program playback

This function enables playback of selected tracks in any desired order. Up to 99 tracks can be selected for pro- gram playback.

1During stop, set the Program or the Mode>Program mode.

2Use the number keys (0~9) on the remote control unit to select each desired track for program play- back, then press the ENTER key.

You can also rotate the MULTI JOG dial to select the track number and push to enter.

The track number will be entered into the program.

Repeat the above step 2 until the desired program is completed. As the program is being created, the pro- gram number and total program playing time is revised on the display.

NOTE

If the CLEAR key is pressed, the programmed track will be deleted from the last.

3When program setting is completed, press the PLAY key to begin playback of the tracks in the pro- grammed order.

NOTE

≠If the STOP key is pressed without first pressing the PLAY key, all the program data will be erased.

≠During stop, if the playback mode is switched to an- other, all the program data will be erased.

≠The programmed play order is not memorized when power is turned off.

≠In this mode, if any track is not programed, the CD- RW900 will not start playback.

≠If an attempt is made to enter more than 100 pro- gram steps, the message PGM Full! appears on the display.

≠If the total program playing time exceeds 999 min 59 sec, --- :--appears on the display.

TASCAM CD-RW900 17