| Operating Your Receiver |
Switching on/off | Selection of Audio/Video source |
•To enter Standby Mode, press the ON/ECO button once.
ON/ECO
When one of the audio/video source is selected, the EN audio and video input corresponding to the name
will be activated.
The receiver acts as a switching device between all the sources that are plugged into it.
Press SOURCE or on the main unit or one of the source buttons on the remote control to access the desired source.
MUTE
•To power on the unit from Standby Mode, press
SOURCE 
or 
button on the main unit or one of the source buttons on the remote control.
BAND TUNI
SOURCE
BAND TU
SOURCE
•To switch off the unit completely, press the ON/ECO button or unplug the power cord from the socket.
Show and Hide Control Panel
When the unit is powered on, touch the OPEN/ClOSE button on the front panel of the unit to show the control panel. Press again to hide the control panel.
UNING | MEMORY | SETUP TEST TONE |
OK
OPEN/CLOSE
NOTE
The unit must be powered on before you can open and close the control panel. Refer to “Switching on/off” above for instructions on powering on the unit.
NOTE
Remote control selector must be on hifi.
Example 1:
If you connect a VCR player to the VCR input (audio
+video) on the receiver and press the SOURCE 
or 
button on the main unit until VCR1/ANL shows on the display. You can also press vcr/V.AUX on the remote to select the source directly. You will be able to have the sound and image transmitted by the VCR.
BAND TUN
SOURCE
NOTE
Remote control selector must be on vcr/sat to operate VCR player.
13
