Getting Started
Inserting Batteries into Remote Control
1. Press the part indicated and push in the direction of the arrow to open the battery compartment door.
2. Insert two AA(LR06) batter- ies according to the + and - signs on the battery compart- ment.
3. Press to close the cover.
To use the remote control, point it directly at your receiver.
Set up and Maintenance of the Receiver
IMPORTANT NOTE
•Provide spaces for sufficient ventilation as indicated below. If the space is insufficient, the unit may over- heat resulting in malfunction and shorter life time.
|
| 10 cm/4" |
|
|
|
| H O M E T H E A T E R A U D I O V I D E O R E C E I V E R D P L 4 0 0 0 |
|
|
10 cm/ |
| VOLUME |
| 10 cm/ |
ON/ECO |
|
| ||
4" |
|
|
| 4" |
| MUTE | BASS/TREBLE |
| LEVEL |
|
| L AUDIO R | VIDEO | |
| PHONES |
|
| |
|
| 10 cm/4" |
|
|
5 cm/ |
|
|
|
|
2" |
|
|
|
|
• Do not connect to the AC power cords until all connections are completed.
EN
•Do not use your set immediately after transferring it from a cold place to a warm place: there is risk of condensation.
•Do not expose your set to water and excessively high temperatures.
•After having disconnected your set, clean the case with a soft cloth, or with a slightly damp leather chamois. Never use strong solvents.
Protect your Components from
Overheating
•Do not block ventilation holes in any component. Arrange the components so that air can circulate freely.
•Do not stack components directly on top of each other.
•Allow adequate ventilation when placing your components in a stand.
•Place an amplifier near the top shelf of the stand so heated air rising from it will not affect other com- ponents. If you have a satellite receiver, you should place it on the top shelf.
3
