USING THE PROJECTOR
This section describes how to use and make adjustments to the projector. It also provides a reference to the keypad and remote buttons and the options available from the
Basic Image Adjustment
1Make sure you have powered up your equipment in the right order (page 13).
2If the image doesn’t display completely, zoom the image (page 17), adjust the height of the projector (page 17) or center the image by adjusting its horizontal or vertical position (page 26). Be sure the projector lens is at a 90 degree angle to the screen.
3If the image is out of focus, rotate the focus lens (page 17).
4If the image appears to shimmer or if it has blurry vertical bars after you have adjusted the focus, turn Auto Image (page 24) off and then back on to reset the automatic sync and tracking. If that doesn’t clear up the image, turn Auto Image off and adjust the sync (page 25) and/or the tracking
(page 25) manually.
5If the colors don’t look right, adjust the brightness (page 21).
Using the Remote Control
To control the computer’s mouse from the projector’s remote or keypad, you must connect the USB mouse connector on the com- puter cable to the computer. See page 10 for details.
The projector ships with a remote that has four function buttons, a disk mouse and two mouse buttons, one on the top of the remote and one on the bottom.
Point the remote control at the projection screen or at the front of the projector (not at the computer). The range for optimum oper- ation is about 25 feet. If you point the remote at the projection screen, the distance to the screen and back to the projector must be less than or equal to 25 feet. For best results, point the remote directly at the projector.
15
