Powering up the Projector and Adjusting the Image
1Remove the lens cap.
2Plug the power cord into the side of the projector, then plug it into your electrical outlet. A
3Press the Power button on the side of the projector.
•The fans start to run, the LED on the top of the projector (Figure 12 on page 18) lights green, and the startup screen appears. It takes about one minute for the image to achieve full brightness.
4If you connected a video player, turn it on.
•The video image should display on the projection screen. If it doesn’t, press the source button on the keypad (page 18) or the video button on the remote to display your video image. You can select a default source to determine which source the projector examines first during
•Use the volume buttons to adjust the volume.
5Turn on your computer.
•The computer image should display on the projection screen. If it doesn’t, press the source button on the keypad or the computer button on the remote to display your com- puter’s image. Make sure your laptop’s external video port is activated; see “Portable and Laptop Activation Chart” on page 44 for details.
•If necessary, make adjustments to the image using the pro- jector’s
NOTE: Always use the power cord that shipped with the projector.
NOTE: The first time you connect your computer to the projector, the computer may display a message stating that new hardware was found. The Add New Hardware Wizard may appear. Use the Wiz- ard to load the correct driver (the computer considers the projector a Plug and Play Monitor).
NOTE: With some computers, the order in which you power up the equipment is very important. Most computers should be turned on last, after all other peripherals have been turned on. Refer to your computer’s documentation to determine the correct order.
13
