Advance Sound Control
Fine Setting of the Speakers
This receiver supports a wide range of speakers and subwoofers. For optimal surround sound enjoyment, you need to register the speaker selection settings of your audio system. If you buy this receiver with accompanied speaker package, then this step has been done for you.
Also, to make the surround sound more effective and suit the acoustic conditions in your listening room, you need to delay the signal from some of the speak- ers. Such channel delay compensates for center or surround speakers that are closer to listening position than the front speakers. You can make use of the SETUP button to adjust the speakers’ relative loud- ness.
The TEST TONE button
You can adjust the relative loudness of the individual speakers by the TEST TONE button.
1.In Surround (Dolby Digital/Pro Logic/DTS) modes, press TEST TONE briefly. A short noise will be heard in the speakers one by one. The speaker having the noise at that moment will be shown in the display.
SETUP TEST TONE EQ DIGITAL INPUT
OK | ST/M | SURR. MO |
|
| |
OPEN/CLOSE |
|
|
2.To adjust the volume level of the test tone, turn up/down the VOLUME knob or press vol + / - key on the remote control.
VOLUME
BASS/TREBLE | LEVEL |
3.To adjust individual speaker volume level, press the LEVEL button when the short noise is played on the speaker you want to adjust then adjust the VOLUME to modify the output level.
EBLE |
| LEVEL |
R | VIDEO |
4.Press LEVEL again to save your setting.
5.Repeat step 3 to adjust other speaker volume lev- els.
NOTE
To adjust the level of all speakers (center and surround speakers), you must select Pro Logic mode first by pressing the SURROUND key
24