Technicolor - Thomson DPL4000 Digital Connections, Connecting the Antennas, Component Connections

Getting Started

Digital Connections

Read instructions carefully when connecting compo- nents to the receiver.

Digital In Jacks can accept Dolby Digital (AC-3), DTS or PCM signals when compatible components are connected.

Connecting the Antennas

EN

COAXIAL DIGITAL IN (AUDIO)

Connect to coaxial digital output of DVD, CD, SAT or other compatible devices.

to COAXIAL OUT (DVD / CD Player / SAT)

OPTICAL DIGITAL IN (AUDIO)

Optical Fiber Cable

Connect to optical digital output of DVD, CD, SAT or other compatible devices.

to OPTICAL OUT ￿ (DVD / CD Player / SAT / TV)

DVD / CD Player / SAT

SAT / DVD / CD Player / TV

The AM and FM antennas connect to the AM and FM terminals on the system’s back panel.

They must be hooked up in order to receive clear reception.

OPTICAL DIGITAL OUT Connect to recording device like ￿

CD, CDRW player, DVD recorder, mini disc etc.

AM Loop Antenna and FM Indoor Antenna

1.Uncoil the Antenna wire and locate the base end of the AM antenna and snap into place as shown below in AM Loop Antenna.

2.Press down on the Antenna tab to open the termi- nal

Component Connections

Component Video In & Out

The Component Video Input is linked to DVD and SAT modes. Selecting DVD or SAT mode will route a component video signal connected to the Component Video IN sockets to the Component Video Out sock- ets. Using dedicated high-quality video cable (not provided), connect the input from a device equipped with Component Video output such as a DVD player. Connect the Component Video output to a display device (TV, monitor) to the Monitor outputs.

TV

DVD SAT

Antenna Wire Connection

Push terminal tab down to	Release tab to lock wire in
insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the Antenna wires at all connection points.

to COMPONENT VIDEO￿	to COMPONENT VIDEO ￿		to COMPONENT ￿
OUT (DVD)		OUT (SAT)	VIDEO IN (TV)￿

5