Installation

Video recorder settings

1Switch on your satellite/cable receiver and select channel 1.

2Set vcr/dvd/tv button on the remote control to vcr a.

3With key menu (13), call up the SUMMARY menu.

4With key ▼ (9) select the Installation line and confirm with ok (11).

5With key ▼ (9) select the Satellite and cable box line and confirm with ok (11).

6Select the country where you live or the country from which you wish to receive the channels, in the case of living on the border, from the list of countries which appears

on the screen and press ok (11).

ð The SATELLITE AND CABLE screen appears

7With keys C(10) or B(8), select the socket to which your satellite receiver is connected:

-either RF or Coax (mono sound); validate with ok (11). The satellite receiver communication channel search screen appears; press C(10) or B(8) to start the search, then validate with ok (11) on completion of the search.

-either AV1 or AV2 and validate with ok (11), then select No decoder (the other options

are rarely used in Europe) and revalidate with ok (11).

8Enter your satellite code number (see the code table at the end of this user manual), then validate with ok (11).

J If the make or model of your satellite/cable receiver is not on the list, try out other model numbers. If no code works, repeat the procedure described on this page by entering the 00; the video recorder then tries out all the codes stored in its memory.

ðVia the infrared window, the video recorder transmits a signal to your satellite

receiver. A confirmation menu comes up while the satellite receiver positions itself on channel 12 (check whether channel 12 is indicated by the display on satellite receiver - occasionally in a slow manner -, even if there is no image to be seen on the television screen).

9Should the satellite receiver not use channel 12, select NO with the exit (12) key. Your video recorder then starts a new search (depending on the make of your satellite receiver, several attempts are possible).

10If the satellite receiver uses the channel 12, select YES with the ok (11) key.

11Press ok (11) key again. Wait for quite a long time (up to 15 minutes) until a message tells you that the storage of your satellite channels is completed.

12Press exit (12) key to leave menu.

ðYour video recorder now controls your satellite receiver.

13Refer to page 5 to sort your satellite channels and check their names.

JIf you should wish to change your satellite receiver, select the Installation line from the

SUMMARY menu then the Satellite and cable line and finally the New installation line.

If you should wish to rearrange your satellite receiver channels, select the Satellite channel identification line from the SATELLITE AND CABLE menu.

JWhen connecting the video recorder to a television set with integrated satellite receiver, you must select the socket AV1 during set-up.

GB

7