Technicolor - Thomson TCW710 manual Overview Front Panel, Connections and Setup

Chapter 1: Connections and Setup

Overview

Front Panel

The following illustration shows the front panel of the Gateway machine:

The LEDs on the front panel are described in the table below (from left to right):

TCW710	WLAN		Ethernet	USB	Cable	Internet	Description
					Link
	OFF		OFF	OFF	OFF	FLASH	Tuning (Searching downstream signal)
	OFF		OFF	OFF	FLASH	FLASH	Ranging - Awaiting Response
							(DS carrier acquire, ranging in process but RNG-RSP
							has not been detected)
	OFF		OFF	OFF	FLASH	FLASH	Any RNG-RSP detected
							(Normalizing power level and timing offset)
Start-up	OFF		OFF	FLASH	FLASH	FLASH	Connecting
							(Ranging complete, DHCP in progress)
Operation
	OFF		FLASH	FLASH	FLASH	FLASH	Configuring
							(DHCP complete, configuration file download in
							process)
	FLASH		FLASH	FLASH	FLASH	FLASH	Registering and Baseline Privacy Initializing
							(configuration file download complete, initialize BPI if
							BPI is ON, registration in process)
		Enter Normal Operation Mode					Registration complete
Normal	X		X	X	X	OFF	Internet ON-OFF switch off
Operation						ON	Internet ON-OFF switch on
					OFF		NO Cable Link
							Cable BSS/OSS has set the CM into de-activated
	X		X	X	FLASH	X
							state
					ON
							CM is registered
	X		X	OFF	X	X	NO USB carrier present
				ON			USB carrier present, no traffic

Illustrations contained in this document are for representation only. 17