Paper Entry/Transport Area, Hot, Heated

Problem Solving

■ Paper Entry/Transport Area

CMake sure that the misfeed indicator goes off after removing all misfed paper.

1	Open the right cover.

2		Remove the misfed paper.
		Remove the misfed paper.
3		If copy paper is fed far into the copier;
		If copy paper is fed far into the copier;
		#Turn the right paper clearing knob.
		$Remove the misfed paper.
4		#Open the heat roller cover.
		$Remove the misfed paper.
		%Close the right cover.
	Caution	Caution: This fuser area may be
	heated	hot.
	surface
		I

ATTENTION CMake sure that the misfeed indicator goes off after removing all misfed paper.

Page 43

Image 43

Technics DP-1810P manual Paper Entry/Transport Area, Hot, Heated, Surface

Contents

Options Before StartingEnglish Others Model and Serial Number Important Information Common Features and Usage Operation Chart Energy Star Table of Contents Options Problem SolvingOthers Manufacturer’s name and address Factory ID PrecautionsFor Your Safety Laser Safety Toner and Paper Ventilation Handling FCC Warning For U.S.A Installation Control Panel Interrupt Key, Memory In Key, M1/M2 Keys Contents Refer to Stop KeyLCD Display Start Key $Select exposure control Basic CopyFull Size Copying Copying the Same Size Originals Size Copying with Preset RatiosReset Reduction or Enlargement Copying Zoom Zoom Copying Sheet Bypass Side Guides Using the Sheet Bypass$Adjust the side guides Copying on Special Paper, etc 1 key Creative FeaturesProcedure 1 Copy Copy Copy Margin Book/Edge/MarginBook Edge $Press the Memory In F2 key Job MemoryTo store a job in memory To recall a job stored in memory Sort Copy Sort CopyFrom Platen Glass only Sleep Mode Other FeaturesEnergy Saver/Interrupt Mode Energy Saver Mode Normal Skyshot ModeDigital Skyshot Mode None Platen Manual Skyshot Mode Copy Combined Function TableOriginal Sort Input Identification Code Using Function Modes to Change the Initial Copy ModesFunction Options General Functions Modes Function Initial Setting Modes Function Copier Settings General Functions for Key Operator Copier Settings for Key Operator Changing the Auto Exposure Setting Function SettingPress the Function Key Proceed as Follows Changing the Paper Size Function Setting for Key OperatorB5R Stopper Guide a Paper Guide b Paper Functions Departmental Counter Select the Department Counter Mode Components Accessories $2 in 1 Copy Automatic Document FeederADF DA-AS180 # Automatic Original Feeding Inappropriate originals Place Original Adding Paper J Problem SolvingSheet Paper Tray Cap Adding the Toner and Replacing Toner Waste Container ? Problem Solving Paper Misfeed Locations Removing a Misfed Paper Paper Exit Area Surface Paper Entry/Transport AreaHot Heated Paper Feed Module ADF Unit Does Not Operate TroubleshootingBefore Calling Service Check Action Marked Copies Light Copies Glass User Error Codes U CodeCode Display Message Check Points Cover DP-1810P Copier Specifications 2nd Paper Feed Module DA-DS182 Specifications Part Name Remarks Options and SuppliesFor Printer SuppliesPage Page Warranty

Problem Solving

■ Paper Entry/Transport Area

heated

hot.

surface