Technics SA-DA10 A To enjoy bi-ampsound, Ensure “BI-AMP”lights when BI-WIREis, selected, Bi-Wire

				Enjoying the sounds
	SPEAKERS A, B		TAPE MONITOR	A To enjoy bi-amp sound
				By using the bi-wiring feature of this unit to connect your
				speakers, you are able to take advantage of two separate
				amplifiers for the high frequency and low frequency ranges. This
				enables more highly defined sound reproduction of the two ranges
				thus producing high quality bi-amp stereo sound.
				Ensure “BI-AMP” lights when [BI-WIRE] is
				selected.
	BI-WIRE	BI-AMP		BI-AMP will turn off and the indicator will go out in the
				following cases
				Á If any of the DSP sound modes are turned on.
A				Á If DVD 6CH INPUT is selected.
				Note
	SPEAKERS
				Á Before pressing [BI-WIRE], connect speakers designed for bi-
A	B	BI-WIRE BI-AMP
				wiring using bi-wiring connection.
				Á Do not select [BI-WIRE] if you have connected two sets of
			SPEAKERS	speakers to the A and B speaker terminals.
			BI-WIRE

B

For front speakers with an impedance under 6 Ω

B

SPEAKERS

A B BI-WIRE

LOW IMP

SPEAKERS

A

Press and hold [A] or [B] until “LOW IMP” lights up on the display.

If even one of the speakers being used has an impedance under 6 Ω, press and hold down either [A] or [B] for 4 seconds or more to set the impedance on the main unit to LOW.

C

TAPE MONITOR

(Press and hold down once again for 4 seconds or more to turn it off.)

Note that when “LOW IMP” is on, SPEAKERS A and B cannot both be used at the same time.

To change speakers:

e.g. To use SPEAKERS B, press [A] (“•” goes out), and then press [B] to activate SPEAKERS B.

C

To use TAPE MONITOR

{For use when you have connected a graphic equalizer to the TAPE/MD (for the United Kingdom) or TAPE (for Australia and New Zealand) terminals.}

Press [TAPE MONITOR].

The “TAPE MONITOR” indicator lights and the tape monitor comes on.

Sources other than TAPE/MD (for the United Kingdom) or TAPE (for Australia and New Zealand) can still be selected with [INPUT SELECTOR] while the “TAPE MONITOR” indicator is on.

Press [TAPE MONITOR] again to turn the tape monitor off.

(\ See “Making a recording” on page 48 for details on how to use the tape monitor during recording.)

Note

Á The tape monitor cannot be used when TV, DVD, or CD digital input is being used.

Á If you are using the tape monitor and you select a digital input source, the tape monitor switches off.

Á Depending on the settings on the graphic equalizer, there may be some distortion.

24

RQT5518