Technics SA-DA10 Press A to select “DISTANCE”, Press B to select the speaker, channel to be set

					Preparatory steps
		4-1	4-3	4	To set “DIST ANCE”
		5-1 4-2	5-2		1 Press [A] to select “DISTANCE”.
					2 Press [B] to select the speaker
					channel to be set.
					Each time you press the button, the display switches as
					follows.
					FRONT		CENTER	SURROUND
					3 Turn [INPUT SELECTOR] to set the
					distance.
	6				Distance can be set at 0.1 m intervals between 1.0 to
					10.0 m.
					The factory settings are as follows.
4					Front and center speakers:				3.0 m
					Surround speakers:				1.5 m
1		SPEAKERS			4 Repeat steps 2 and 3 to
	A	B			complete the size settings for the
					front, center and surround
					speakers.
				5	To set “FIL TER”
2		SPEAKERS			1 Press [A] to select “FILTER”.
	A	B			2 Turn [INPUT SELECTOR] to set the
					cut off frequency.
					Each time you turn the selector, the display switches as
					follows.
					100	150	200
3		INPUT SELECTOR			The factory setting is 100 Hz.
				6 Press [A] and [B] at the same time.
					“COMPLETE” appears on the display.
				If you allow about 10 seconds to elapse between settings, the
				procedure is canceled, all settings are returned to how they were,
				and the previous display is restored. Begin again if this occurs.

5

SPEAKERS

1 A B

For your reference

The settings remain as they are until changed by the above procedure, even after the power has been turned off.

2 INPUT SELECTOR

6 SPEAKERS

A B

18

RQT5518