TechniSat S1 manual Satellite scan, Transponder scan, Scan mode

Bed_anl_.qxd 20.02.04 16:29 Seite 51

programmes) or whether you want to include encrypted programmes (All programmes).

>Confirm by pressing the red function key Start scan.

The scan may take more than 15 minutes. Please note any on-screen messages displayed.

8.4.2 Satellite scan

UTo scan a specific satellite for programmes, select the option Satellite scan (Fig. 8-16).You can select whether you wish to scan for all programmes (free-to-air and encryp- ted) or only for free-to-air programmes.

>Press the OK key again to open the selection table of active satelites.

>Use the up/down arrow keys to mark the line All satellites to scan all active satellites for program- mes, or mark the desired satellite to scan only this for programmes.

>Confirm by pressing OK.

>Use the up/down arrow keys to mark the field

Scan mode.

>Use the OK key to select whether you wish to scan only for free-to-air programmes (Free programmes) or whether you wish to include encrypted programmes (All programmes).

>Press the red function key Start scan.

The scan will be started. Please note an y messages displayed on screen.

>You can stop the scan at any time by pressing the red function key.

8.4.3 Transponder scan

You may scan a specific transponder (see Point 10 Technical terms) for programmes. To do this, you will have to enter the transponder data (Fig. 8-17).

Satellite

In this line, select the satellite on which the desired transpon- der is located.

>Use the up/down arrow keys to mark the line

Satellite.

>Press OK to display a table showing the active satelli- tes.

>Now use the up/down arrow keys to mark the des- ired satellite.

>Confirm by pressing OK.

The selected satellite will now be indicated in the line Satellite.

Transponder frequency

> Use the up/down arrow keys to mark the line

(Fig. 8-7)

(Fig. 8-8)

51