TechniSat S1 manual Technical Terms, Delete satellite position, Reference position

Bed_anl_.qxd 20.02.04 16:29 Seite 62

(Fig. 9-1)

(Fig. 9-2)

(Fig. 9-3)

(Fig. 9-4)

While the positioning procedure is in progress, the blinking message “turn” will be displayed in the menu.

9.4.1 Selecting a satellite position

In order to turn the dish antenna to the position specified in

the satellite list, your digital receiveris equipped with the function turn to Sat.

>Press the yellow function key Actions to open the window displaying the actions available.

>Use the up/down arrow keys to mark the line turn to Sat.

>Confirm by pressing OK.

>Press the green key (turn to Sat), the antenna will be turned toward the satellite position selected.

9.5 Delete satellite position

To delete a satelite position from the satelite list, proceed as follows:

>Use the arrow keys to mark the field Current satellite list.

>Press OK to display the current satellite list.

>Use the up/down arrow keys to select the satellite you wish to delete.

>Confirm by pressing OK.

>Use the arrow keys to mark the field Sat delete.

>To delete the selected satellite, press OK, then confirm the screen prompt by pressing OK again.

9.6 Reference position

When installing the extern al installation, the rotary motor must be in the reference position (0°). This allows you to move the motor position back to this reference position (0°) at any time by means of the command “Go to reference position”..

>Press the red function key Ref.pos to rotate the antenna automatically to the reference position.

10 Technical Terms

Antenna cable:

Connecting cable between the modulator of the satellite recei- ver and the antenna input of the television set. Used as an alternative where no SCART socket is availabe

External installation:

Term used to describe the whole system mounted externally, consisting of the parabolic or offset dish as well as one or more LNCs, to provide reception from one or more satellites

AV: see SCART

62