Tefal FV4190K0 DRY Ironing, Maintaining Your Iron, Cleaning the ANTI-CALC Valve Once per month

Auto-Stop safety feature (depending on the model)

-The electronic system cuts off the electric power and the Auto-Stop warning light flashes if the iron is left vertically on its heel for more than 8 minutes, or in a horizontal position for more than 30 seconds.

-To restart the iron, just move it gently until the warning light stops flashing.

Note:When the Auto-Stop warning light is on, it is normal for the thermostat light to be off.

2- DRY IRONING

-Set the steam control on DRY (see diagram A).

-Set the temperature.

-You may start ironing when the thermostat light goes out and comes on again.

3- MAINTAINING YOUR IRON

BE CAREFUL !

Unplug your iron and let it cool off before cleaning it.

•CLEANING THE ANTI-CALC VALVE (Once per month) :

-Unplug your iron and empty the water tank.

-To remove the anti-calc valve, pull it up using the tabs located on each side (N).

NEVER TOUCH THE END OF THE VALVE.

-Soak the rod in a cup of white spirit vinegar or plain lemon juice for 4 hours (O).

-Rinse the valve in tap water.

- Place the steam control on dry. - Replace the anti-scale valve.

THE IRON WILL NOT FUNCTION WITHOUT THE ANTI-CALC VALVE

O

•USING THE SELF-CLEANING FUNCTION

In order to extend the life of your iron, use the Self-Cleaning function once per month.

-Unplug your iron and set the steam control on DRY .

-Fill the water tank up to the limit (see recommendations for the types of water to use).

-Leave water tank filler cover open until the end of the operation

-Place your iron on its heel and set the thermostat control on MAX.

-Plug in your iron and wait until the thermostat light goes out.

-Unplug the iron and hold it over a sink in the horizontal position.

4- Place the steam control on MAX.

M

N