•This appliance complies with applicable technical rules and standards at time of manufacture.
•It is designed to run only on alternating current. Please check before first use that the mains power supply corresponds to that indicated on the appliance's rating plate.
•Do not place or use this appliance on a hot plate or close to a flame (gas cooker).
•Only use the appliance on a flat stable heat resistant working surface away from water being splashed. Do not turn it upside down.
•Disconnect the appliance:
-if it is not working correctly,
-before cleaning or maintenance,
-after use or if it has been left unattended,
-on each accessory change.
•Never pull the power cord to disconnect the appliance.
•Before using an extension lead, always first make sure it is in good condition.
•You must not use a household electrical appliance if:
-it has been dropped,
-the blade is damaged or incomplete.
•If the power supply cord is damaged, it must be replaced by the manufacturer, the manufacturer’s authorised Service Dealer, or a person with similar qualification, to avoid any risk of danger.
•This product is designed for domestic use only. Any commercial use, inappropriate use or failure to comply with the instructions, the manufacturer accepts no responsibility and the guarantee will not apply.
•Do not use your fingers to push meat into the grinding unit. Always use the pusher.
•This appliance is not intended for use by children or persons who may suffer from a mental and/or physical impairment – unless they are adequately supervised in its operation and use by an adult responsible for their safety. Persons who have a limited or no understanding in the operation and use of this appliance must first read and fully understand the contents of these instructions and where appropriate seek additional guidance on its use from an adult responsible for their safety.
Description
1. | Motor unit | 9. | Nut |
2. | Pusher | 10. | Funnel for sausages (according to model) |
3. | Feeder tray | 11. | “Kebbé” mincing tool (according to model) |
4. | Button to unlock grinding unit | 12. | Biscuit maker (according to model) |
5. | Grinding unit |
| 12a: support |
6. | Screw |
| 12b: mould |
7. | Blade | 13. | Juice and coulis accessory (according to model) |
8. | Grids (according to model) |
| 13a: screw |
| a. small holes – dia. 3mm |
| 13b: filter with combined holes for coulis |
| b. medium holes dia. 4.7mm |
| 13c: juice guide |
| c. large holes dia. 7.5mm | 14. | Door |
Handle the blade with caution as it has very sharp cutting edges.
Before first use, wash all accessories with soapy
95