Jitter Measurement Commands
C–40 WFM 601A, WFM 601E & WFM 601M User Manual
Jitter Measurement Commands
The commands in this section allow you to change parameters for the Jitter
measurement display.

JITter:HPFILter <J10HZ | J1000HZ | J10KHZ | J100KHZ> (WFM 601M Only)

Selects the high-pass filter frequency for the Jitter measurement display.
This setting corresponds to the Jitter HPF selection in the Config Jitter menu.
JITter:HPFILter <J10HZ | J1000HZ | J10KHZ | J100KHZ>
JITter[:HPFILter]?
<J10HZ | J1000HZ | J10KHZ | J100KHZ>
jit:hpfilter j1000hz
jit:hpfil j10khz
jit?
:JITTER:HPFILTER J10KHZ;UNITS UI;ALIGNMENT 0.11 UI;TIMING 0.10
UI

JITter:UNITS <SEC | UI | OFF> (WFM 601M Only)

Selects the units for the readout of jitter magnitude.
JITter:UNITS <SEC | UI | OFF>
JITter[:UNITS]?
<SEC | UI | OFF>
jit:units OFF
jit:units?
:JITTER:UNITS OFF
Syntax
Arguments
Examples
Returns
Syntax
Arguments
Examples
Returns