
Table of Contents |
| |
Safety Messages | i | |
Table of Contents | iii | |
List of Figures | iv | |
List of Tables | iv | |
1.0 | INTRODUCTION | 5 |
2.0 | GETTING STARTED | 7 |
2.1 | Unpacking | 7 |
2.2 | Electrical and Pneumatic Connections | 7 |
2.3 | Initial Operation | 9 |
3.0 SPECIFICATIONS, WARRANTY | 11 | |
3.1 | Specifications | 11 |
3.2 | Warranty | 12 |
4.0 THE | 13 | |
4.1 | Principle of Operation | 13 |
5.0 CALIBRATION AND ZERO/SPAN CHECKS | 15 | |
5.1 | Calibration or Cal Check Procedure | 16 |
6.0 MAINTENANCE | 19 | |
6.1 | Maintenance Schedule | 19 |
6.2 | Replacing the Sample Particulate Filters | 20 |
6.3 | Checking Analyzer Flow Rate | 22 |
6.4 | Replacing the Converter | 22 |
6.5 | Inspecting Pneumatic Lines | 24 |
6.6 | Checking for Leaks | 27 |
7.0 | TROUBLESHOOTING, ADJUSTMENTS | 29 |
7.1 | Operation Verification – Diagnostic Techniques | 30 |
7.1.1 Pneumatic System | 30 | |
7.1.2 Leak Check | 32 | |
7.1.3 Bypass Pump Diagnostic Procedures | 32 | |
7.1.4 Electrical Fault Isolation | 32 | |
7.2 | Setting the Converter Temperature | 32 |
7.2.1 Temperature Controller Setup | 32 | |
05386 Rev. D | iii |