Drawings & Schematics | Teledyne IGE 3000 instruction

10.Drawings & Schematics

High Low

F1

F2

Emis DGas SP K Fil

2X=On/Off

HASTINGS

IGE 300

Page 21 of 21

Image 21

Teledyne IGE 3000 instruction manual Drawings & Schematics

Contents

Teledyne Hastings Manual Print History Table of Contents IGE To Turn on the TUBE’S Filaments Quick Start Information General Information SpecificationsGeneral Information IGE-3000 Mini Bayard/Alpert B/A Tube Materials exposed to Vacuum Installation InstallationReceiving Inspection Mounting B/A Tube Installation Connector Electrical Pin outsMounting B/A tube to IGE-3000 Electronics Module Environmental Operation Apply PowerOperation Front Panel Overview Operating Modes Factor Mode DGas ModeFil filament Mode SP set point Mode Remote Filament Control Bayard Alpert B/A Tube Theory of Operation Advance Setup Guide Set Up GuideRS485 Address Baud Rate Restore Eeprom Turnaround DelayData Bits/Parity Bits/Stop Bits Save Eeprom Wiring for IGE-3000 RS232/485 Wiring for RS232/485 RS 232/RSRS232/RS485 Command Syntax Device StatusION Gauge Device Status 4-DIGIT Octal Word Interrogation Commands Parameter Modification CommandsCommand Description Format Sample Response Non-Warranty Repair Policy Warranty Repair Policy Drawings & Schematics