Industrial Modem MIU56 User Guide
M4 |
| Speaker on during dial, answer, retrain or rate change |
O1 |
| Enter |
O2 |
| Retrain, donÕt go |
O3 |
| Change line speed to 4800 bps (V.32 & V.32bis) |
O4 |
| Change line speed to 7200 bps (V.32 & V.32bis) |
O5 |
| Change line speed to 9600 bps (V.32 & V.32bis) |
O6 |
| Change line speed to 12000 bps (V.32 & V.32bis) |
O7 |
| Change line speed to 14400 bps (V.32 & V.32bis) |
P |
| Pulse dialling |
Q0 | | Modem returns response codes |
Q1 |
| Modem does not return response codes |
Q2 |
| Modem does not return RINGING or response codes when answering |
R9 |
| 9600 bps (locked terminal speed - no autobaud) |
R14 |
| 14,400 bps (locked terminal speed - no autobaud) |
R19 |
| 19,200 bps (locked terminal speed - no autobaud) |
R28 |
| 28,800 bps (locked terminal speed - no autobaud) |
R38 |
| 38,400 bps (locked terminal speed - no autobaud) |
R57 |
| 57,600 bps (locked terminal speed - no autobaud) |
R115 |
| 115,200 bps (locked terminal speed - no autobaud) |
R230 |
| 230,400 bps (locked terminal speed - no autobaud) |
Sn? |
| Display value in S Register ÔnÕ |
Sn=x |
| Place ÔxÕ in S Register ÔnÕ |
T | | Tone dialling |
V0 |
| Numeric response codes |
V1 | | Verbal response codes |
W0 |
| CONNECT message reports the terminal speed |
W1 |
| CONNECT message reports the terminal speed |
W2 | | CONNECT message reports the line speed |
X0 |
| Basic response codes (codes |
X1 |
| Extended response codes (codes |
X2 |
| Extended response codes (codes |
X3 |
| Extended response codes (codes |
X4 |
| Extended response codes (codes |
X5 | | Extended response codes (codes |
X6 |
| Extended response codes (codes |
Zn |
| Restore configuration profile n (n=0,1,2,3) |
&B0 |
| 8 bit character length |
&B1 |
| 9 bit character length |
&B2 |
| 10 bit character length |
&B3 |
| 11 bit character length |
&B4 | | 10 or 11 bit character length determined by autobaud |
&C0 |
| DCD signal always asserted |
&C1 | | DCD signal responds to remote modem |
&C2 |
| DCD signal always on, pulses low on disconnect |
&C3 |
| DCD asserted during voice session |
&D0 |
| Ignore DTR |
&D1 |
| Return to Local command state if DTR goes low |
&D2 | | Hangup & return to Local Com if DTR goes low, disable |
|
| asserted |
&D3 |
| Initialise with values in &Y profile if DTR goes low |
&F0 |
| Restore factory defaults |
MIU56Robert Way | Page 14 | 2/28/2003 |
